Installation Guide

16. Assemble the Inside Panel
NOTICE: The inside panel roller mounting holes are 5″ (127 mm) below the top of the panel.
NOTICE: The inside rollers contain a brass insert.
Position each roller on the same side of the panel as the label.
Install each inside roller with the tab on top. This will position the door at its highest setting,
allowing for easier adjustment if necessary.
Secure each roller with a #10-24 x 1-1/4” screw.
Using a hand screwdriver only, securely tighten the screws.
#10-24 x 1-1/4"
Spacer
Roller
x2
Brass Insert
5"
(127 mm)
Tab Up
Clamp
Axle
Kohler Co. 19 1279162-2-A