Remote Installation Sheet

3. Reconnect
NOTE: The blower motor must be located within 15’ (4.6 m) of the bath, with no more than six direction
changes in piping.
NOTE: The blower motor must be oriented horizontally, and installed to a support block no lower than
the original mounted height relative to the bath.
NOTE: Refer to the ″Before You Begin″ section for other detailed requirements for the blower motor
relocation.
At the new blower motor location, install a minimum 1-1/2″ (38 mm) high block (not supplied) for
the blower motor support.
Use the blower motor as a template to mark the location of the four mounting bolts or screws.
Drill four pilot holes for the blower motor mounting screws.
Fasten the blower motor to the support board.
Route PVC or other 1-1/2″ piping (not supplied) between the bath and the blower motor location.
Connect each previously cut end of the PVC with the provided 1-1/2″ couplings.
Route the provided cable from the new blower motor location to the bath. Use cable ties or other
support clips (not supplied) to support the cable.
Connect the cable to the blower motor. The cable connector at the blower should be oriented with
the flat part facing up.
Use the provided retaining clip to prevent accidental cable disconnection.
Connect the cable to the user interface.
Ensure that any wall holes are properly sealed as required by local building or fire codes.
4. Make Electrical Connections
WARNING: Risk of electric shock. To reduce the risk of electric shock, connect the control to a
properly grounded Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD). This
will provide additional protection against line-to-ground shock hazard.
Make electrical connections according to the Installation Guide packed with the bath.
Complete the bath installation according to the Installation Guide packed with the bath.
Retainer
Clip
Cable
Kohler Co. 5 1037564-2-D