Remote Installation Sheet

1. Prepare Site
Prepare the site for the bath installation and blower motor installation. Refer to the installation
instructions packed with your bath.
Install the required access panel to service the blower motor.
Prepare routing paths for the PVC piping and the keypad cable. Follow all applicable building, fire,
plumbing, and electrical codes.
2. Disconnect
IMPORTANT! Do not cut, remove, or uncoil the coiled piping for this installation.
Cut the middle of the 1-1/2″ PVC pipe located between the tee and the union nut.
Disconnect and remove the cable connecting the blower motor and the user interface.
Cut the straps holding the blower motor to the support board on the bath.
Prepare, install, and secure the bath. Refer to the installation instructions packed with your bath.
Strap
Tee
Union Nut
Cut here.
1037564-2-D 4 Kohler Co.