Installation Guide Continued

2. Disconnect
For Blower Motor without Check Valve Only
IMPORTANT! Do not cut, remove, or uncoil the coiled piping if attached to the bath.
Cut the middle of the 1-1/2″ PVC pipe located between the tee and the union nut.
Disconnect and remove the cable connecting the blower motor and the user interface.
Cut the straps holding the blower motor to the support board on the bath.
Prepare, install, and secure the bath. Refer to the installation instructions packed with your bath.
Strap
Tee
Union Nut
Cut here.
1037564-2-E 6 Kohler Co.