Installation Guide

2. Freestanding Supply Installation
Remove the temporary plugs from the water supply couplings.
Replace the long rod with the short rod for Kohler models
K-710, K-711, K-712, K-726 and K-727. To determine the bath to
drain faucet measurement for your model bath refer to the
″Roughing-In″ section of this manual.
Thread the tee bracket into the hole in the back of the overflow
elbow.
Insert the rod into the tee bracket and secure with the setscrew.
Install the Supply Tubes
Loosen the setscrews in the pipe holder and flange.
Carefully slide the plated supply pipe through the pipe holder
and flange.
Thread the supply pipe into the supply rough-in and tighten it
with a strap wrench.
Tighten the setscrews in the pipe holder and flange.
Repeat for the second supply tube.
Rod
Setscrew
Pipe
Holder
Tee
Bracket
Overflow
Elbow
Plated Supply Pipe
Setscrew
Pipe
Holder
Tee Bracket
Flange
Kohler Co. 5 1008209-2-F