Installation Sheet

16. Install the Threshold Cover and Filler
Left Pivot Right Pivot
Threshold Filler Threshold Filler
Outside of
Shower
Inside of
Shower
Threshold Cover
IMPORTANT! Do not cut the threshold cover.
NOTE: The threshold cover must slope toward the inside of the shower.
NOTE: The large at surface of the threshold
ller should face the outside of the shower.
Snap the threshold cover into place on the threshold as shown.
The threshold cover should not hang over the ends of the threshold. Do not cut the threshold cover.
Remove the threshold cover, partially pull the threshold out of the wall jamb, and adjust the position of the xed panel
and the threshold as described in the "Locate the Fixed Panel" section.
When the threshold cover no longer hangs over the end of the threshold, place the threshold ller that corresponds to
the pivot type over the end of the threshold cover.
Kohler Co. 21
1409304-2-B