Installation Sheet

2. Install the Remote Dock
1/16"
or 1/4"
Holes
Remote Dock
Remote Control
Batteries
Position the remote dock at the desired mounting location.
Conrm that the remote dock is level.
Using a pencil, mark the two mounting-hole locations. Set the remote dock aside.
For installation into a stud or other wood surface: Drill a 1/16″ hole at each of the
marked locations.
For installation using wall anchors: Drill a 1/4″ hole at each of the marked
locations. Install the provided wall anchors into the holes.
Position the remote dock over the anchors or marks. Secure the remote dock with
the provided screws.
Open the baery compartment on the remote control. Install the four provided
AA baeries in the orientation shown.
Position the remote control on the remote dock.
7
Kohler Co.
1354689-2-B