Installation Sheet

2. Prepare the Cabinet
IMPORTANT! Before installing this sink, verify that the distance
from the top of the cabinet to the top of the doors is greater than
8-13/16″ (224 mm).
TIP: Apply painter’s tape to the cabinet to mark the cuts and protect
cabinet surfaces when cutting.
Measure and mark the hole locations.
Drill 1″ holes at each marked location.
Mark vertical lines from the hole to the top of the cabinet as
shown.
Cut away the front panel of the cabinet as shown.
Notch the front face of the cabinet 1/4″ (6 mm) as shown to
accommodate the thickness of the sink rim. The top of the sink
should be flush with the top of the cabinet when installed.
7-3/4"
(197 mm)
1-1/2"
(38 mm)
1/4"
(6 mm)
Ø 1"
(25 mm)
Kohler Co. 5 1368036-2-A