Installation Guide

5. Install the Valve Bodies
Remove and save the washer and nut from the end body valves.
Install a flexible hose to each valve body outlet. Tighten securely,
but do not overtighten.
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheon according to the putty manufacturer’s
instructions.
NOTE: The valve body marked ″COLD″ with blue lettered tape
attached to the tube should be installed to the right of the faucet.
From the top of the bidet, insert the valve bodies into the proper
mounting holes.
Rotate each valve body until the copper tubing faces toward the
outside of the bidet and the outlets face each other.
Slide a washer and loosely thread a nut onto each valve body.
Firmly hold the valve bodies in place and then securely tighten
the nuts with a wrench. Do not overtighten.
Remove any excess putty or sealant.
End Body
Apply
plumbers
putty.
Escutcheon
Washer
Nut
End Body
Outlet
Washer
Nut
End Body
Hose
O-Ring
1054192-2-A 8 Kohler Co.