Installation Guide

5
113345-2-BA (B)
Kohler Co., Kohler, WI
Place nylon washers, flat washer and retaining nut onto
ball lever. Insert ball lever assembly into drain lever hole
and tighten retaining nut.
Check that ball lever points to back of lavatory. Tighten
locknut on drain body. Remove excess putty.
NOTE: Do not reposition drain after locknut is tightened.
Fig. #8
Retaining Nut
Flat Washer
Nylon Washer
Ball Lever
Nylon Washer
Drain
Lever
Hole
Drain
Lever
Hole
Ball Lever
Assembly
Locknut
Thread thumb screw into connecting link. Slide one end
of “V” -clip onto ball lever rod. Slide connecting link onto
ball lever rod with thumb screw facing rear of lavatory.
Squeeze other end of “V” -clip, aligning hole with ball lever
rod. Move connecting link to proper position by squeezing
“V” -clip and sliding along ball lever rod.
Push ball lever rod down into open position. Insert stopper
into drain body.
Fig. #9
Thumb
Screw
Connecting
Link
Ball Lever Rod
“V”-Clip
Stopper
With drain in open position, slide lift rod into hole in con-
necting link. Position lift rod so that lift rod knob is against
lift rod tube, then tighten thumb screw.
Fig. #10
Lift Rod Knob
Lift Rod
Tube
Thumb
Screw
Lift Rod
Connecting
Link