Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 50″ (1270 mm) x 24″ (610 mm)
Basin area, top 65″ (1651 mm) x 27″ (686 mm)
Weight 110 lbs (49.9 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 72 gal (272.5 L)
* Approximate measurements for comparison only.
Drop-in cut-out 70″ (1778 mm) x 34″ (864 mm)
Pump: V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
41 lbs/square foot (200 kg/square meter) loading.
The apron must be installed before the finished floor and wall
materials are installed.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
7-1/2"
(191 mm)
Pump/Control
Access
20" (508 mm) W x
15" (381 mm) H
18" (457 mm)
1-13/16"
(46 mm)
10-1/4"
(260 mm)
3-1/2"
(89 mm)
72" (1829 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
20"
(508 mm)
18-1/2"
(470 mm)
1-1/2" OD
No change in measurements
if connected with drain illustrated.
(K-7161-AF or K-7161M-AF)
Recommended Faucet Area
1-1/2"
(38 mm)
Drop-in Rim
Detail
36" (914 mm)
Product Diagram
MARIPOSA
®
MARIPOSA
®
BATH WHIRLPOOL WITH CUSTOM PUMP
Page2of2
1012668-4-
E