Specification Sheet

1"
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
120 V, 15 A, 60 HzBlower, Amplifier,
Heated Surface:
Technical Information
Provide one grounded electrical outlet within 24"
(610 mm) of each component.
All product dimensions are nominal.
Drop-in, Under-mountInstallation:
Control amplifier fits 16" (406 mm) center studs.
25' (7.6 m) cables are included.
EndDrain location:
44-1/2" x 26-1/2" (1130 mm x 673 mm)Basin area, bottom:
One electrical service may be used for the entire
bath and related electrical components.
60-1/4" x 30-1/4" (1530 mm x 768 mm)Basin area, top:
115 lbs (52.2 kg)Weight:
Remote blower installation kit K-1446 is available
for relocating the blower. Provide access for
servicing the blower.
64 lbs/ft² (312.5 kg/m²)Minimum floor load:
17-3/4" (451 mm)Water depth:
102 gal (386.1 L)Water capacity:
Do not relocate or alter the PVC tee or coiled
flexible tubing connected to the blower. Follow
the blower relocation instructions exactly.
Drop-in, 65" x 35" (1651 mm x 889 mm)Cutout:
Blower: 120 V, 10 A, 60 Hz, 300 W
Amplifier: 120 V, 1.2 A, 50/60 Hz, 15 W
Electrical component
rating:
Heated Surface: 120 V, 0.5 A, 60 Hz, 65
W
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
11-21-2016 02:13
Underscore
®
5.5' VibrAcoustic
®
BubbleMassage
™
Bath
K-1173-GVBCW