Installation Guide

TP-6906 4/1628 Section 1 Installation Instructions
Note: See Figure 1-13 for cable specifications.
1. Customer connection terminal block. See Figure 1-10 for location. Check the decal on the generator se t for terminal block connections.
2. Splice
3. Connect all of the shield leads on this end to GROUND at the generator set.
2
tp6809
Generator Set
COM
PWR
B
A
3
COM
PWR
B
A
9402 CABLE
9402 CABLE
RBUS
12VDC
3
1
Figure 1-16 Multiple Connections to the Generator Set
tp6809
Generator Set
TB1
Notes:
D See Figure 1-10 for terminal block location on generator set. Check the
decal on the generator set for terminal block connections.
D See Figure 1-13 for maximum total cable length with 12 or 14 AWG
wire.
D See Figure 1-14 for communication connection (A and B, PWR and
COM) details. Connect the cable shield to ground at the generator set.
PIM
RXT ATS
Load
Shed
Kit
Figure 1-17 Accessory Module Connections (two cable runs with one and two modules shown)
1.4.10 Other Accessories
Install and connect optional accessories. Follow the
installation instructions provided with the accessory
kits. See Section 2 for information about available
accessories.