Installation Guide

TP-6906 4/16 27Section 1 Installation Instructions
RXT*
COM
COM
PWR
COM
PWR
PWR
B
A
B
A
B
A
COM
PWR
B
A
COM
PWR
B
A
4
2
3
5
Load Shed Kit
PIM
COMA PWRB
1. Generator set terminal block. See Figure 1-10 for location. Check the decal on the generator set for terminal block connections.
2. Connect one end of each cable shield to GROUND at the generator set.
3. Communication cable. See Figure 1-13 for cable specifications, including maximum total cable l ength.
4. Connect shields together as shown.
5. Leave one end of each cable shield disconnected at the last device.
6. 12 AWG or 14 AWG leads for PWR and COM.
Note: See Section 1.4.8, Communication Cable
Specifications for maximum cable lengths.
* RXT transfer switch with s tandard or combined interface/load
management board. Do not use a load shed kit with a
combined interface board.
6
Generator Set
GND
A
B
COM
PWR
1A
1
RBUS
12VDC
1
4
3
Figure 1-15 Accessory Module Connections with 12--14 AW G Power Leads (one cable run with three modules
shown)