Manualshelf

Full Product Manual

ManualsBrandsKOHLER ManualsGeneratorsRCA 14,000-Watt Air-Cooled Whole House Generator (Canyon Blue)
21222324252627282930
24 TP-7092 4/23
Figure 17 Carburetor Heater, 20 and 26 kW Models
1.8.7 Emergency Stop Kit
An emergency stop button is available as a loose kit. Pressing the emergency stop button causes the generator set to shut down
immediately. The generator controller displays an emergency stop shutdown message after the button is pressed.
E-stop assembly harness contains the E-stop, contact block, and two leads connected to the contact block. The harness is
factory-assembled. The kit also includes the emergency stop switch decal.
The generator set enclosure is designed with an opening for the emergency stop button. Install the emergency stop button as
described in the TT-1613 and TT-1795 instructions.
RDC2 firmware to version 5.5 or higher is required for E-stop operation. Use a personal computer (laptop) and Kohler
®
SiteTech™ software or the USB Utility to update the controller firmware, if necessary. See TP-6701, SiteTech Operation Manual,
or TT-1636, Firmware Update Using the USB Utility, for instructions if necessary.
1.8.8 Load Management
Two optional load management devices are available for use with single-phase generator sets and a model RXT or RDT transfer
switch.
• The optional Load Shed Kit mounts inside a model RDT or RXT transfer switch.
• The combined interface/ load management board is available for the Model RXT transfer switch.
The devices provide an automatic load management system designed to comply with applicable NEC requirements (ref. article
702 for Optional Standby Systems). The installer is responsible for ensuring that the power system installation complies with all
applicable state and local codes.
Note:
The load management devices are only compatible with single-phase generator sets.
The load management device automatically manages up to six residential loads. Two relays are provided to control two
independent air conditioner loads. Up to four power relay modules can be connected for management of non-essential secondary
loads.
The load management device is controlled by the RDC2 controller. The load on the generator set is monitored, and loads are
added or shed in the order of their priority. See the installation instructions provided with the load shed kit or the Model RXT
Operation and Installation Manual for more information.
Heating element
1/8 NPT threaded fitting
GM88228
Power cord disconnect plug
Thermostat
120 VAC plug
240 volt 3-pin plug
GM57968