Dimensions Guide

SYNCHRONY
1.25>132
PUMP/CONTROL ACCESS
(IF APRON IS NOT USED)
1-1/2” O.D.
42”
21”
1-11/16”
8-11/16”
60”
3-9/16”
2-7/8”
3”
1”
18-1/2”
20”
REQUIRED ELECTRICAL SERVICE
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
PRODUCT INFORMATION
Fixture*: basin area top area weight
Bathing well 42” x 25” 52” x 34” 105 lbs.
water depth capacity
To overflow 14” 63 gal.
* Approximate measurements for comparison only.
Pump: HP V Hz A
1-speed 3/4 120 60 10.5
INSTALLATION NOTES
NOTICE: Unless otherwise specified, floor support under whirl-
pool must provide for a minimum of 80 lbs./square foot loading.
If installing a rim-mount faucet, make sure there is no interfer-
ence with drain overflow and circulating system before drilling
any holes. Consult local and national codes for minimum air
gap requirements if installing a spout on the faucet deck.
The apron must be installed before the finish floor and wall
materials are installed.
Each pump is supplied with grounding-type plug-in cord. Locate
the outlet behind the whirlpool, and within 24” of the pump.
Roughing-In Notes
No change in measurements if connected with drain
illustrated.
Cut-out 58” x 40”
Faucet area recommended
Minimum access panel:
Pump/control 20” W x 15” H required
K-1192, K-1196 Synchrony  5’ Bath Whirlpool
Page 2 of 2
87972-4-AB
PRODUCT DIAGRAM