Installation Guide

3
Kohler Co., Kohler, WI
113504-2-
AA (A)
 Drill a 1/4” mounting hole at the
mark on the floor, then drill two
1/4” hanger bolt holes at the
marks on the wall.
 Mount hanger bolts to the wall
so approximately 3/4” of each
bolt remains exposed.
NOTE: Other fastening devices of
sufficient size and strength may also
be used.
Finished Wall
Hanger
Bolts
 Install the faucet and drain to
the lavatory according to the
manufacturer’s instructions.
NOTE: Do not fully tighten slip-joint
drain connections at this time.
 Position the pedestal mounting
hole over the hole in the floor.
 Secure the pedestal to the floor
with the wood screw and
washer. Tighten the screw until
it is snug.
CAUTION: Risk of product
damage. Do not overtighten.
Overtightening may cause
damage to the product.
Pedestal
Wood Screw
Washer
 Set the lavatory on the pedestal
so the hanger bolts extend
through the lavatory holes.
 Level the lavatory.
 Install the cap nuts and
washers, and tighten until snug.
CAUTION: Risk of product
damage. Do not overtighten the
cap nuts. Overtightening may
cause damage to the product.
 Connect and tighten the trap to
drain. Connect the hot and cold
water supplies to the faucet.
Finished
Wall
Hanger
Bolts
Cap Nut
Washer
Lavatory
Pedestal