Dimensions Guide

12-3/16"
(310 mm)
3-15/16"
(100 mm)
23"
(584 mm)
1-3/8"
(35 mm)
1-3/16"
(30 mm)
23-3/16"
(589 mm)
46"
(1168 mm)
1-1/2"
Bath Drain
7/16" (11 mm)
6" (152 mm)
72" (1829 mm)
Pump/Piping Protrudes Beyond
Rim 2-3/4" (70 mm) Max
Note:
Pump/Control Access
34" (864 mm) W x
15" (381 mm) H Min
No change in measurements
with drain shown. (K-7273)
5-1/2"
(140 mm)
9-1/2"
(241 mm)
7-1/2"
(191 mm)
7" (178 mm)
6-3/4" (171 mm)
Lumbar
Angle 35°
20"
(508 mm)
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
220-240 V, 20 A, 50/60 HzPump, Heater:
Technical Information
All product dimensions are nominal.
Kit is required for under-mount installations (sold
separately).
Drop-in, Under-mountInstallation:
EndDrain location:
Pump/piping protrudes beyond rim (see drawing).
43" x 26-1/2" (1092 mm x 673 mm)Basin area, bottom:
55" x 36" (1397 mm x 914 mm)Basin area, top:
160 lbs (72.6 kg)Weight:
43 lbs/ft² (209.9 kg/m²)Minimum floor load:
19-1/4" (489 mm)Water depth:
96 gal (363.4 L)Water capacity:
Drop-in, 1016369-7, required, includedTemplate:
Pump: 240 V, 11 A, 50/60 Hz
Heater: 220-240 V, 6.25 A, 50/60 Hz, 1500
W
Electrical component
rating:
VariablePump speed:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
12-1-2017 04:55
Purist
®
6' Whirlpool Bath
K-1110-V