How to Guide

Product Information
Applicable product:
Bath/shower valve trim with 1/2″ IPS
threaded spout
K-T10055-9
Shower valve trim, less diverter spout K-T10056-9
Mixing valve trim K-T10057-9
Bath spout K-10044
Required accessories:
Rite-Temp
®
valve OR K-304-*
HiFlow Rite-Temp valve with stops
OR
K-2971-KS
Rite-Temp valve with diverter OR K-11748-K
Rite-Temp valve with diverter and
stops
K-11748-KS
* For a complete listing of all the Rite-Temp valves, refer
to the K-304-* Specification Sheet or Roughing-In sheet.
Optional accessories:
HiFlow Rite-Temp
®
thin wall installation kit 88526
Deep rough-in kit – for use with K-304-K,
K-304-KP, K-304-KS, and K-2971-KS
1073881
Deep rough-in kit for valves with push
button diverter – for use with K-11748-K
and K-11748-KS
1092535
Installation Notes
Install this product according to the installation guide.
Install the Rite-Temp valve according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install a shut-off device on
either valve outlet.
Cap the shower outlet if the deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install a 7″ (17.8 cm) to 18″ (45.7 cm) straight pipe or straight
tube with single bath elbow between the valve and the
wall-mount spout.
1/2" NPT
1/2" NPT pipe must extend
3/8" (1 cm) - 1/2" (1.3 cm)
beyond finished wall.
7-1/8"
(18.1 cm)
1/2" Hot
5-5/8"
(14.3 cm)
6-3/8"
(16.2 cm) D.
1/2" Cold
10" (25.4 cm)
4" (10.2 cm)
6-7/8" (17.5 cm)
2-3/4" (7 cm) Thin Wall
2-3/4" (7 cm) - 3-1/2" (8.9 cm)
Thick Wall
Top of The Rim
48" (121.9 cm)
to Floor
(Shower Only)
72" (182.9 cm) -
78" (198.1 cm)
to Floor (Typical)
2"
(5.1 cm)
4"
(10.2 cm)
2"
(5.1 cm)
4-3/8"
(11.1 cm)
Roughing-In
K-T10055-9, K-10044, K-T10056-9, K-T10057-9
OBLO
®
RITE-TEMP
®
BATH/SHOWER VALVE TRIM
OBLO
®
RITE-TEMP
®
BATH/SHOWER VALVE TRIM
1091244-1-
C