Installation Sheet

Installation Guide SKU#32294
USA/Canada: 1-800-4 KOHLER 1446242_8_A
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damage. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a
clean and soft cloth to protect finish. Confirm all parts are included.
2. Place decorative ring (H) over the shade (G). Then set decorative ring (H)
on the lip of shade (G).
3. Loosen screws (E) and then remove mounting plate (B) from canopy (F).
4. Attach mounting plate (B) onto outlet box with screws (D). Ensure
ground screw (C) is attached to mounting plate (B).
5. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wire to the green or bare copper wire in
outlet box with wire nut (A) or fasten onto ground screw (C) on mounting
plate.
6. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture white wire to the white wire in outlet box with wire nut (A). Wrap
the wire connector with electrical tape so that the tape seals the end of
wire nut (A), see diagram 1.
7. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
the fixture black wire to the black wire in outlet box with wire nut (A).
Wrap the wire connector with electrical tape so that the tape seals the
end of wire nut (A), see diagram 1.
8. Insert quick connector into the opposing quick connector end.
9. Tuck wires carefully inside outlet box. Attach the canopy (F) onto
mounting plate (B) with screws (E).
10. NOTICE: Do not exceed recommended wattage. Rated Max 60 W,
Type A19. (Bulb(s) not included).
11. Install bulbs to the sockets.
12. Restore power to circuit at breaker or fuse box.
CLEANING: Please clean fixture with a soft and dry cloth ONLY. Clean glass
with a mild soap.
Approved fastener
(
Wire nut
)
Electrical ta
p
e
Phillips &
Flathead Screwdriver
Wire
Cutter/stripper
Electrical Current
Teste r
Electrical
Tape
Diagram 1