Installation Sheet

Installation Guide SKU#23347, SKU#23342
USA/Canada: 1-800-4 KOHLER 1391084_2
www.kohler.com
Approved fastener
(Wire nut)
Electrical tape
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
5. Your product may appear different than the one illustrated. The installation procedures remain the same.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a clean and soft
cloth to protect finish. Confirm all parts are included.
2. Thread wire through rod (I), connector (H) and rod (G), (F), canopy (E), ball joint (D),
and safety cord (N). Secure all the parts onto fixture (J) firmly.
3. Trim excess cord to minimum 6” beyond the canopy (E), wire stripping to 5/8” at the
end and twist.
4. Attach mounting plate (B) onto outlet box with screws (C). Ensure the direction of
ground screw (P) is as shown.
5. Lift fixture, lace safety cord (N) around mounting plate. Then, secure it with lock (O).
6. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten fixture green
or bare ground wire to the green or bare copper wire in outlet box with wire nut (A)
or fasten onto ground screw (P) on mounting bar. Fasten either fixture wire to the
white wire in outlet box with wire nut (A). Wrap the wire connector with electrical
tape so that the tape seals the end of wire nut (A), see diagram.
7. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten other fixture
wire to the black wire in outlet box with wire nut (A). Wrap the wire connector with
electrical tape so that the tape seals the end of wire nut (A), see diagram.
8. Tuck wires carefully inside outlet box. Attach canopy (E) onto ceiling. Then, secure it
with screws (M). Make sure the slot on the ball joint (D) matches the salient point on
the canopy (E).
9. NOTICE: Do not exceed recommended wattage. Install lamp(s). Rated Max 60 W, Type
G/T/A/B. (Bulb(s) not included).
10. Install glass (L) onto glass holders with screws (K).
11. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
Phillips &
Flathead
Screwdriver
Slip Joint
Pliers
Small
Adjustable
Wrench
Wire
Cutter/stripper
Electrical
Current
Tester
Electrical
Tape
Allen
Wrench