Manualshelf

Installation Sheet

ManualsBrandsKohler Lighting ManualsIndoor Ceiling FixturesSimpalo 15" LED Flush Mount Ceiling Light
1234
Installation Guide
SKU#22518
USA/Canada: 1-800-4 KOHLER 1408409_2
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a
clean and soft cloth to protect finish. Confirm all parts are included.
2. Attach mounting plate (B) onto outlet box with screws (C).
Ground screw (G) is as shown.
3. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wire to the green or bare copper wire in
outlet box with wire nut (A) or fasten onto ground screw (G) on
mounting plate.
4. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture white wire to the white wire in outlet box with wire nut (A).
Wrap the wire connector with electrical tape so that the tape seals the
end of wire nut (A), see diagram.
5. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
the fixture black wire to the black wire in outlet box with wire nut (A).
Wrap the wire connector with electrical tape so that the tape seals the
end of wire nut (A), see diagram.
6. Press together the two connectors (D).
7. Tuck wires carefully inside outlet box. Rotate canopy (E) onto mounting
plate (B), attach the canopy (E) onto mounting plate (B) by securing
screws (F).
8. Restore power to circuit at breaker or fuse box.
WARNING: For dimming of this fixture, only compatible dimming devices
as outlined on the spec sheet are allowed. Visit www.kohler.com to view
the spec sheet.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
Approved fastener
(Wire nut)
Electrical tape
Phillips &
Flathead
Screwdriver
Slip Joint
Pliers
Small
Adjustable
Wrench
Wire
Cutter/stripper
Electrical
Current
Tester
Electrical
Tape

Summary of content (4 pages)