Download

Before first use
1. Unpack the appliance, then check to ensure that all the accessories are included. If
not, contact Kogan Support.
2. Install the ice maker on stable, level surface with sufficient ventilation (at least
25cm), far from heat sources such as ovens, heaters and corrosive gases to ensure
good operation.
3. The ice maker cabinet should never exceed 45°. Do not turn upside down. This can
cause the compressor or refrigerating system to operate incorrectly. Please allow
time for the fluids in the compressor to settle after the ice maker is moved or
transported (at least 30 minutes). Before using the ice maker for the first time,
please wait for 2 hours after installation.
How to use
Ensure that the drain plug at the bottom of water reservoir is closed well.
1. Plug the ice maker into the wall outlet: the “Ice” indicator will blink.
2. Open the top lid and remove the ice basket.
3. Fill the water reservoir with drinking water.
4. Replace the ice basket and close the top lid.
5. Press “On/Off” and the “Ice” indicator will become solid.
6. The ice-making cycle will last approximately 7-15 minutes, depending on the
ambient temperature and water temperature.
7. The ice-making cycle starts with water being pumped into the ice tray situated
below the evaporator. Over the next 7-15 minutes ice forms on the evaporator. Once
this has completed, the ice tray will tilt backwards and the remaining water in the
ice tray is drained back into the water reservoir. The ice cubes are then dropped
from the evaporator and pushed forward into the ice basket by the ice shovel. The
ice tray will automatically move back into position under the evaporator and start
the next cycle.
OPERATION
Notes:
• Clean before first use. (See “Cleaning & Care”)
• Do not fill the water reservoir with hot water. This may damage the ice maker. It is
best to fill the water reservoir with water of room temperature or lower.
• Do not use the appliance in very cold environments (lower than 5°C).