HUNTING TRAIL CAMERA 24MP KAHUTRCA810A
OVERVIEW 44PCs IR LED Latch LED Indicator Lens Central PIR Sensor Side PIR Sensor
Colour Display Screen 8AA Batteries Depot Setup Buttons Mode Switch USB Port Micro SD Card Slot Stand Knob Port External Power Port IN THE BOX Camera Quick Start Guide Mounting Strap USB Cable
INSTALLATION If Using AA-Alkaline Batteries 1. Pull the gap lightly and open battery compartment. 2. Refer to the battery icons located on the inside of the battery compartment. Insert the batteries according to the positive and negative battery icons. 3. Close the battery compartment tightly to ensure water and dust resistance. Note: Installing any AA battery in the wrong direction may cause the batteries to leak acid or explode, causing camera failure and damage to the battery compartment.
If Using 6V DC Power Source 1. Remove the rubber port cap at the bottom of the camera. Plug a universal 6V DC cord into the bottom port. 2. Run the cord to the side of the camera where there is a hook provided behind the hinge of the camera door. This will support the power cord and take pressure off of the connection point. 3. When not in use, replace the rubber port cap at the bottom of the camera to protect the 6V DC universal plug-in port.
Memory Card Installation 1. Insert the Micro SD card with the contacts facing away. The Micro SD card should slide in freely with little resistance. Continue pressing the card inward until you hear a click. This means the Micro SD card is locked in place and ready for use. 2. To remove Micro SD card, press the card inwards to release.
OPERATION Quick start Slide the mode switch from OFF to TEST position to activate the camera and view the user setup screen. There is a control panel with 8 keys when you open the camera. Operating Buttons MENU REPLAY Open the Settings menu using the MENU button. Press this button to start the replay mode. Change to the manual recording mode for videos. Change to the manual recording mode for taking photos. SHOT Manually take a video or photo depending on the set recording mode.
Auto Recording Mode After entering settings, slide the power switch to ON to enter auto recording mode. The motion indicator will flash red for about 5 seconds, after which the camera will start working. It will automatically take pictures or record videos when a person or animal enters into the area of the PIR sensor. Caution: To avoid potential false triggers due to temperature and motion disturbances, do not aim the camera at a heat source (e.g.
Camera Menu Settings Camera Sub menu Description Resolution 24MP, 20MP, 16MP Photo size Sequence 1/3/6/9 Number of photos taken sequentially ISO Auto,100, 200, 400 Camera exposure level Delay 1/5/10/30 sec/min Delay between shots Camera ID 0-0-0 0-0-0 Camera ID Video Menu Settings Video Sub menu Description Resolution 1080P, 720P, VGA Video size Video length 10S, 30S, 60S, 90S Time length of video Record audio ON, OFF Whether sound is captured or not
Setup Menu Settings Setup Sub menu Description Mode Camera, video, camera and video, interval Image, video, image + video, image taken at set interval Language English, French, German Camera menu language Time-lapse interval 5/30/60 Min Taking picture or video for every 5/30/60 minutes constantly TV Mode NTSC, PAL AV output mode Date/Time 2018-09-03 16:37:25 YYYY-MM-DD HH:MM:SS Timer ON, OFF Enable operation only during set period Password **** 4-digit password (universal password: 1
SPECIFICATIONS Power 4 or 8 x AA alkaline/lithium batteries external DC6V~12V (3.5 x 1.
TROUBLESHOOTING Camera doesn’t capture subject of interest Check the PIR sensitivity for warm environmental conditions. Set the Sensor Level to “Low”; for cold weather use, set the sensor to “High”. Set your camera up in an area where there are no heat resources in the camera’s field of view. In some cases, setting the camera near water will make the camera to take images with no subject in them. Aim the camera over ground. Set the camera on stable and immovable objects, i.e., large trees.
Need more information? This is a Quick Start Guide, and we hope that this has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.
