FOLDABLE ZENITH DRONE WITH FPV WI-FI CAMERA KAZENTDRONA & KAZENTDBATA
SAFETY & WARNINGS WARNING • Read these instructions thoroughly before use. • Do not discard of these instructions. • Improper operation may cause serious personal injury or property damage. • The product is not suitable for children below 14 years of age. It is not a toy. • Ensure the device is operated with care at all times, and used only as directed in these instruction. • The flight site must be a legal remote control model flight site.
COMPONENTS Number Name 1 Qty Number x1 8 Name Qty x4 Protective frame Main body cover 2 x1 9 PCB board Main body under cover 3 x4 10 Propellers 4 Gear x1 12 x1 13 x1 USB Charger Rear left arm x1 Rear right arm x1 Battery Front right arm 7 x4 11 Front left arm 6 x4 Motor x1 5 x1 14 x1 Camera Board
OVERVIEW Remote Control Headless mode / One key Return 360 Degree Roll / Emergency stop Speed switch Photo / Video Rightward micro adjusts Leftward micro adjusts Forward micro adjusts One key takes off One key landing Backward micro adjusts ON / OFF Switch
INSTALLATION 1. Remote Control Battery Insert batteries in remote control, paying attention to the battery polarity (+/-) as per the illustration below. 2. Connect the USB cable to the computer to charge To charge the device, connect the battery plug to the USB charging cable, and insert the USB end into a computer or compatible USB adapter. The indicator light will be on when charging, and off once full. Do not leave on charge when full. 3.
ASSEMBLY 1. Folding function When folding, begin by folding each arm at the centre point and then folding the complete arm toward the body as one. When expanding, complete the same steps in reverse. 2. Arm and propeller installation The ‘A’ arms should be installed to the upper left and the lower right corners of the drone. The ‘B’ arms should be mounted to the upper right and the lower left corners of the drone. At the corner of each arm, install the propellers.
3. Protective frame installation Position the protective frame at the drone’s arm and install fastening, as per below image. Repeat these steps for all four arms. Please note, the drone will not lift off if the protective frames are not securely attached. Ensure they are tightly installed before operating the device. 4. Attaching remote control thumbsticks The remote control will arrive with the thumbsticks separate, as shown below.
INSTRUCTION 1. Install mobile phone client Please scan the corresponding QR code to download and install the app. Open in web browser (Apple iOS and Android) Google Play Store (Android) 2. Operation instruction Enter the Settings, open the Wi-Fi option and find the device Wi-Fi hotspot name “YD_XXX_UFO_XXXXX” and connect. After successful connection, return to the desktop, open the downloaded app and enter the program.
OPERATION Remote Control 1. Mobile phone rack Pull out the remote control lower bracket to clamp the phone. 2. Turning on Place the drone on a flat surface, and then turn the power switch on. The drone indicator light will flash. Turn on the remote control, push the throttle joystick to the highest and then pull to the lowest. You will hear a “tick” sound. The drone indicator light is on, match the right frequency to complete (2.4G frequency), then you can take off.
4. Flight Control A.
B. Forward and backward (right lever) (with camera front side) Push the right lever upwards The aircraft is advancing Push the right lever down The aircraft is backwards C.
D. Turn left and right (with camera front side) Turn the left lever to the left Aircraft turn left Turn the left lever to the left Aircraft turn left 5.
About fine tuning Right side Left side Take off the body when the right shift, according to the left micro adjustment is correct Take off the body when the left shift, according to the right micro adjustment is correct Directional definition, selecting headless mode Headless Mode sets the front of the drone to be in one direction, regardless of the orientation of the drone. Typically, you will activate headless mode so that the 'front' of the drone is facing away from you.
Once you are ready, press the Headless Mode button on the top left of the remote. Once you take off, the flight heading will be set. When flying in headless mode, the remote control will play a “flute” sound twice to indicate. The drone lights flashes. Press the remote controller button, a “flute” sound prompts and exits Headless Mode. One Key Return One Key Return Mode returns the drone by travelling backward from its current position.
The Remote Controller The photo/video button, or the mobile phone app, can be used to take pictures or record video. You can view your video on your mobile and also start filming video or tale pictures through the app using Wi-Fi. Wi-Fi aerial version of the phone can find Wi-Fi connection and remote control to start the video or take pictures. When there is no connection to the app, you can use the SD card for later viewing.
Emergency landing: 1. During the flying time, if it needs an emergency stop, press the button (as picture shows), the drone will stop working. (Please do not attempt this operation while the drone is flying in high altitude) 2. When the drone leans over 45 degrees, it will stop to protect the engine. 3. When using the app to control the drone, slide the throttle down and press the one key take-off button for an emergency landing.
Button instruction: 1. Return 8. Switch 15. Emergency stop 21. Throttle 2. Take photo 9. Extra Settings 16. Landing 22/23. Left/Right roll 3. Record video 10. Camera flip 17. 360 rolls 24/25. Forward/Backward 4. Media 11. VR mode 18. Marking flight 26/27. Left/Right 5. Speed level 12. Headless 19. Speech Recognition 28/29. Forward/Backward trim 6. Gesture photo 13. Gyro calibrate 30/31. Left/Right roll trim 7. Gravity control 14. Take off 20.
Gravity sensor mode: Click on the icon to enter the gravity sensor mode, after entering the mode successfully, the icon shows the yellow indication, so that you can shake the phone to control the drone forward, back, left fly, the right side fly. Click the icon again to return to normal mode. Take pictures: Control the direction to the drone to the location where you need to take pictures; click the camera icon, each shot a picture.
Voice command control-axis drone Turn on the drone power switch, click on the high icon in Figure 1 and then click on the button in Figure 2 for Voice command control. Figure 1 Figure 2 Note: The camera lens of the drone indicates the front of the drone.
Push up the left joystick (throttle), the main motor speed increases, the drone rises. Push down the left joystick (throttle), the main motor speed decreases, drone descends. Rise Descend Left push the left joystick (throttle) to turn left the drone and push the left joystick to the right (throttle) to turn right the drone. Turn Right Turn Left Push the right joystick up (rudder) to move the drone forward and push down the right joystick (rudder) to move the drone backward.
Push the right joystick to the right (rudder), to move the drone right side and the right joystick (rudder) to left to move drone left side. Fly left Fly right Note: Push the left joystick (throttle) to take off. When the drone is turned in the air or laterally, uses the fine adjustment function to correct the action. If the drone rotates clockwise while in take off, adjust the right-hand fine-tune key until it returns to normal.
If the drone rotates counterclockwise while in take off, adjust the left rotation fine-tuning key. If the drone drifts directly to the left when taking off, press the right side to fine-tune the key until it returns to normal. If the drone drifts directly to the right when taking off, press the left side to fine-tune the key until it returns to normal.
If the drone is moved backwards, press the forward-tune key until it returns to normal. If the drone moves forward, press the back-tune key until it returns to normal. Note: When the drone is less than 30cm from the ground, it may be affected by magnetic currents generated by the ground and become unstable. The lower the drone attempts to fly, the greater the ground effect force.
TROUBLESHOOTING Symptom The drone batteries are inserted and the five indicator lights are flickering. Cause / Issue Remote control and drone connection are not successful Solution Please re-perform the remote control and the flying drone connection Check if the remote control and the flying drone are powered Turn on the remote control on. and insert the drone battery. The drone batteries are inserted and the five Check whether the remote indicator lights stop control and the drone battery flickering.
NOTES
NOTES
Need more information? This is a Quick Start Guide and we hope that this has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.
