Download

OPERATION
Insert the adaptor into the socket located on the product and plug it into an electrical
outlet.
1 – Rotation Mode
Mode 1: Operation ON/OFF
Mode 2: Turn clockwise. Rotate for 2 minutes and rest for 6 minutes then repeat.
Mode 3: Turn counter-clockwise. Rotate for 2 minutes, then rest for 6 minutes, then
repeat.
Mode 4: Turn both clockwise and counter-clockwise. Rotate for 2 minutes in one
direction, then rest for 6 minutes. Rotate for 2 minutes in the opposite direction and
then rest for 6 minutes. Repeats above cycle.
Mode 5: Turn both clockwise and counter-clockwise. Rotate for 5 minutes in one
direction and then rotates in the opposite direction for 5 minutes. Repeats
continuously for 3 hours, then rests for 9 hours. After the 9
th
hour, it will begin the
above cycle again.
2 – Door Sensor
Some watch winders have this function. When the function is turned on, opening the
cover will stop the motor working (so you can change the watch). When you close
the cover again, the motor will continue to work.
NOTE: Most watches on the market require clockwise winding. Some brands may
require counter-clockwise winding or even alternating rotation. Please consult with
your watch manufacturer or watch manual for further information.
ATTENTION
• When inserting and removing a wrist watch, please ensure the electrical power
is off as it may cause malfunction.
• Please remove the A/C adapter when the watch winder is not in use.
• Do not place or remove a watch on the watch holder while it is moving.
• Please dispose of this product responsibly at an approved disposal or recycling
facility. Do not dispose of this product in normal household waste.
• To stop the winder rotating, turn of the power or lift the lid while the door
sensor mode is on.