Download

9
Cleaning & Care
Before using your ice cube maker, it is strongly recommended to clean it thoroughly.
Unplug the unit before cleaning or performing maintenance.
1. Take out the accessory parts under top window.
2. Clean the interior with diluted detergent, warm water and a soft cloth. First, pour the
warm water with diluted detergent into the internal water reservoir and the space
below the transparent window and then use the soft cloth to
wipe the surface.
3. Use water to rinse the interior parts and drain out the water by unplugging the drain
cap on the bottom.
4. The exterior should be cleaned regularly with a mild detergent solution and warm
water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use for a long time, open water drain cap to drain water
completely from water reservoir.
W
arning: Fill with potable water only.
N
ote: Gas inside the unit is flammable.
Specifications
Protection type
I
Climate type
N /SN/ST/ T
Power
220-240V/50Hz
Ice making current
0.8A
Ice harvest current
1.0A
Refrigerant
R600a/23g
Vesicant
C
5
H
10
Net Weight
9.5kg
Enclosure
Plastic
Troubleshooting
Problem
Possible cause
Solution
“ ” symbol is ON and
the arrow flashes.
Water reservoir is low.
Stop the ice cube maker, fill water and
press “ON/OFF” button again to restart
the unit.
“ ” symbol is ON and
letter
“F” flashes.
There is too much ice.
Remove some ice from the chamber
No ice cube inside.
There may be an obstacle or some dirt
he internal sensor. Remove
the obstacle and clean the unit.
Ambient temperature
sensor breakdown
The unit can still work but suggested to
contact Kogan.com Support or an
electrical technician to replace with a
new sensor.