User`s guide

Scanner Configuration Utility
VirtualReScan (VRS) User’s Guide
87
Figure A-2. Scanner Manufacturer List
Note The scanner manufacturer list consists of VRS-certified scanners, as
well as any scanner for which a driver has been installed on your computer.
4 Click Set as Default, which accomplishes the following:
 Creates a set of standard sources (if they do not already exist) for the
selected scanner
 Sets the selected scanner as the default scanner
 Sets the default source for the default scanner (the selection will be based
on the license that is currently in effect)
 Sets default image processing properties that go into effect when the
default scanner is in use with your VRS software
5 Notice that the entries for the “Current default scanner” and “Current default
source” are updated at the bottom of the Scanner Configuration Utility dialog
box.
6 Click Close to exit the utility.
The newly created source(s) will be available from your scanning application.
Configuring a Scan Source - Custom Method
This section explains how to use the Configure Sources dialog box to configure a
source for a scanner that is not certified or compatible with VRS. You may need to use
this method if you are using a scanning application that requires a custom source with
a specific naming convention.