User`s guide

Advanced Properties
VirtualReScan (VRS) User’s Guide
117
printed less than 20 mm from the top of the page. The maximum is dependent on
paper size. Whole numbers are required when entering pixels and millimeters. When
values are in inches, however, they can be entered in .01-inch increments. The Left
edit box is disabled (grayed out) unless annotation is selected.
Note Not all scanners allow you to select a top and/or left position for your endorser
string. Refer to your scanner documentation for more information.
On the right side of the Text Definition dialog box is the Page Counter group, which is
used to enable the page counter, specify a starting number for your automatic
endorser/annotation counter, set the number of digits to use, and determine the
amount by which the counter will be incremented.
Enable
Select the Enable check box to activate the Page Counter feature. When the Enable
check box is clear, all other elements in the Page Counter group are disabled.
Digits
The page counter length can be specified via a drop-down list (which is available only
when the Enable check box is selected). The available values depend on the scanner as
well as on the installed endorsing hardware. The list contains only the available
values for page counter length. Select None if you do not wish to increment the
counter.
Start At
The starting page counter value is set to 1 initially, but it may be reset using the Start
At text box. When you start a new batch, the Page Counter Starting Value is the next
number in the sequence based on the final page counter value from the previous
batch. Again, you are free to enter a new value into the Start At text box instead.
Step Value
Select from the Step Value drop-down list to determine how the automatic endorser/
annotation counter is incremented on every page. The counter should be set based on