Technical Manual

Coding Technical Manual CCM10404715 Page 6 of 10
Coding Technical Manual 2020/04
4. Operation
The CCM10404715 reads the data from the tags on the consumables cyclic. It also
recognizes when a tag is missing.
With each add of a consumable, the AJ5 printer increments a counter on the RFID tag.
So the printer recognizes when a consumable is empty and generates a message for the
user to change the consumable. The level of the consumables is shown in GUI (in
percent)
Changing a consumable bottle requires the following steps:
- Open the front door
- Screw up the cap from the empty consumable bottle and remove it (with tube)
- Remove the bottle from bottle cage (After a while the printer should recognize the bottle
is removed)
- Take a new, full consumable bottle (be careful to take a compatible ink or solvent type)
and insert it in the bottle cage. Insure that the RFID tag is on the correct side near to the
CCM10404715 (After a while the AJ5 printer should recognize the new bottle).
- Screw up the cap from the new bottle and insert the cap with tube from the Printer.
- Close the cap
- Close the front door
- Confirm in the Printer’s GUI that the consumable has been changed