Datasheet

Parts No: KSM-200LM5R
7. Electrical Characteristics
* Don't recommend Rp & Cp2
1) Rs (Vcc input series resistor) : 100 ohm ~ 470ohm
2) Cp1(Vcc-GND terminal series Condenser) : 47uF ~ 100uF
3) Rp (Vcc-Vout terminal Pullup resistor) : Optional (when using 10K ohm or more )
When Rp is lower than 10k, Micom can't reply by a VoL rise.
4) Cp2(Vout-GND terminal pararllel Condenser) : Optional (when using 100pF less than)
*4. B.P.F Center Frequency(fo) of each model is shown below
KKC-QM-043-2(B) 3/8
REFERENCE
Max. Unit
[ Ta= 25, Vcc= 5.0V ]
Parameter
Supply Voltage Range Vcc 2.7
Current Consumption Icc
No Input
Signal
Vcc=5V
Vcc=3V - 0.8
Symbol
Condition
Min.
-
Typ.
- 5.5 V
2.0
1.0
mA
-nm
B.P.F Center Frequency *4 fo - *4 -
Peak Wavelength *3
Arrival Distance *3 L 250Lux
0˚
±30˚
940λp -
20 - - m
24 - - m
500 - 700
H Level Output Voltage *3
V
OH
30cm over the ray axis
Vcc-0.5 V
L Level Output Voltage *3
V
OL
- 0.2 0.5 V
Vcc-0.3 -
L Level Output Pulse Width *3
T
WL
500 - 700
H Level Output Pulse Width *3
T
WH
Burst Wave = 600
Period = 1.2ms
under the conditions below against the standard transmitter
1) Measuring place : Indoor without extreme reflection of light
2) Ambient light source : Detecting surface illumination shall be irradiate 200±50Lux under ordinary white
Output Form Active Low Output
Note :
*3. It specifies the maximum distance between emitter and detector that the output waveform satisfies the standard(8-2,3)
400p-p under the measuring circuit specified in drawing(8-2,3)
4) Application Circuit
fluorescence lamp without high frequency lightning
3) Standard transmitter : Burst wave indicated in drawing(8-1) of standard transmitter shall be arranged to
KSM-2001 Series 40.0
KSM-2002 Series 36.7
Model NO.
B.P.F Center Frequency()
KSM-2005 Series 56.9
KSM-2003 Series 37.9
KSM-2004 Series 32.7
Vcc
GND
Vcc
GND
Vout
Cp1
Rs
Receiver
Module
Micom
Cp2
Transmitter
Rp