User's Manual

54
Stop the alarm tone
When the alarm sounds, press any key to stop. But the guard zone function is still
working, the alarm may sounds again. To "OFF" the guard zone function, select "OFF"
from GZ menu.
Note1: To switch the IN or OUT mode, refer to “Guard Zone Mode” in section
5.5.4.5.3 “Changing
the content of settings 2 (PRESET2)”
Note2: To set the guard zone level, refer to “Guard Zone LeveL” in section
5.5.4.5.3 “Changing the
content of settings 2 (PRESET2)”
5.5.2.3 Shifting display in specific direction (OFF-C)
Displaying the location specified by the cross cursor as the vessel's location.
(1) Select OFF-C from the pull-down display items using up-down cursor key, and press the
"ENT" key.
(2) When the ON/OFF sign is displayed beside the OFF-C item, select ON with the up-down
cursor keys and press the "ENT" key.
(3)
OFF-C
is displayed at the upper right and "SET OFF CENTER POINT" at the bottom of
the screen, and setting is ready to be entered. Move the cross cursor with the cursor
keys to move the ship’s to the intended location, and press the "ENT" key. The ship’s
location will be displayed at the cursor's location. The display at the upper right will be
normalized from the reverse state, which indicates that the "OFF-C" state is entered.
(4) To cancel “OFF-C” function, either select OFF in (2)
Up/Down
-->
ENT
-->
Up/Down
(Select OFF-C) |
-->
(Select ON) ENT
-->
Left/Right & Up/Down
-->
ENT Set
OFF-C
-->
(Select OFF) ENT -----------------------------
Cancel OFF-C
Note: VRM2 and EBL2 do not follow the OFF-C function while floating.
The function operates only on PPI screen.
5.5.2.4 Setting of the SLEEP function(SLEEP)
This function sends a 30-second-transmissions during pre-fixed hours. After a
transmission, a power-saving mode is entered with the screen in ST'BY state (the scanner-OFF
.75
.25
HU
.75
.25
HU
SET OFF-C POINT
OFF-C
Move the cross cursor indicates "OFF-C" state is entered