User's Manual

5.4.8 Erasing heading maker temporarily (HDG OFF)

Press the “HDG OFF” key. The heading marker is not displayed as long as you hold it down.

5.4.9 Using parallel cursors (///CSR)

Press the “///CSR” key. Parallel cursors will appear on the screen. As you move EBL, the

parallel cursors also move.

To cancel the "///CSR" function, press "///CSR" key once more.

Note: Refer to "5.5.1.8 Using parallel cursors (///CSR)".

5.4.10 Establishment of the indication of the RANGE RINGS (RINGS)

Press the “RINGS” key. Range Rings will appear on the screen. To cancel the "RINGS"

function, press "RINGS" key once more.

Note: Refer to "5.5.1.9 Establishment of the indication of the RANGE RINGS (RINGS)".

5.4.11 ON/OFF of variable range function (VAR RNG)

Usually the range changes in steps as 0.5--0.75--1.5--3.0--....., but using this function will

enable a consecutive change such as 0.5--0.6--0.7--0.8--..... .

Press the “VAR RNG” key. The VAR RNG function becomes valid and VAR will be displayed

at the upper left of the screen (beside MODE). To cancel the "VAR RNG" function, press "VAR

RNG" key once more.

The range changes continuously with the up-down cursor while the VAR RNG function is

on, and it changes in steps with the "RANGE UP" or "RANGE DOWN" keys.

If pressing other keys, return to the normal state from continuously range change state.

5.4.12 Changing display modes (MODE)

(1) Select MODE from the pull-down display items using the up-down cursor keys, and press

the "ENT" key.

(2) When the HU/HS/NU/CU/TM sign is displayed beside the MODE item, select display mode

with the up-down cursor keys and press the "ENT" key.

(3) The setting will be completed when the "ENT" key is pressed after the selection. (NOTE1,2)

Press the "MODE" key, the display mode will change on every pressing to HU, HS, NU, CU,

TM in order. The mode select at the upper of the screen is indicated. However, a setting will be

needed for the ship’s speed if TM is selected. Also, a heading or a course information is

necessary for NU, CU and TM.

νοτε: ΤΜ ισ ϖαλιδ ονλψ ον ΠΠΙ σχρεεν. Τηε µοδε ωιλλ χηανγε το ΝΥ ον τηε οτηερ σχρεεν

αυτοµατιχαλλψ.

Note: Refer to "5.5.2.1 Changing display mode (MODE)".

5.4.13 Guard Zone (GZ)