User's Manual

33
(1) When the "STC" key is pressed, the STC display on the left side of the screen will be
reversed as
S 35
and the adjustable state will be entered.
(2) When the control knob is turned, the figure will be shifted within a range of 0 and 99,
and the STC can be manually adjusted. When the "AUTO" key is pressed, all (GAIN,
STC and FTC) will enter an AUTO state.
(3) After the adjustment is finished, press the "STC" key to exit from the adjustment state.
If some other function key is pressed, shift to that function will take place.
(a) To make adjustments by MANUAL (When the STC key is pressed under AUTO operation,
shift to a manual operation will take place.)
STC
→ Control knob → STC
----------------------------The adjustment state is ended.
→Other function key
• --------Shift to other functions
→ AUTO
→ AUTO
--------------------------STC, GAIN, and FTC are set at AUTO and the
adjustment state is ended.
NOTE) When you select MANU mode, GAIN and FTC will be switched to MANU mode, too.
(b) To switch from the MANUAL state
AUTO -------------------------------------------------------------------------Set STC, GAIN and FTC at AUTO
5.3.8 Removing rain and snow clutter (FTC)
(1) When the "FTC" key is pressed, the FTC display
on the left side of the screen will be reversed as
F 500
and the adjustable state will be entered.
(2) When the control knob is turned, the figure will
be shifted within a range of 0 and 99, and the
sensitivity can be manually adjusted. When
the "AUTO" key is pressed, all (GAIN, STC and
FTC) will enter an AUTO state.
(3) After the adjustment is finished, press the
"FTC" key to exit from the adjustment state. If
some other function key is pressed, shift to
that function will take place.
(a) To make adjustments by MANUAL (When the FTC key is pressed under AUTO operation,
shift to a manual operation will take place.)
FTC
→ Control knob → FTC
-------------------------The adjustment state is ended.
µθ
>
Other function key
-------Shift to other functions
µθ
>
AUTO
µθ
>
AUTO
------------------------GAIN, STC, and FTC are set at AUTO and the
adjustment state is ended.
(b) To switch from the MANUAL state
AUTO -------------------------------------------------------------------------Set GAIN, STC and FTC at AUTO
. 75
.25
HU
F 50
ST’BY
+