User Manual
Table Of Contents
- Before You Start
- Safety Notes
- Contents
- Getting Ready
- Operation Method
- Turn On / Off
- Set your Language, Date and Time after the first power-on
- LCD Screen Display
- Introduction to Basic Operation of Recording and Shooting
- LCD Screen Display under Playback Status
- Introduction to Basic Operation of Playback
- Introduction to the Setting Mode of Menu Options
- Menu Introduction
- Introduction to General Settings
- Introduction to Mode Settings
- Movie Settings Introduction
- Still Settings Introduction
- AP Settings Introduction
- Connecting the Camera with the Smart Device
- Smart Device APP Operating Method
- Connection Port Introduction
- Appendices
- Special Accessories
97
2. Tie one end of the tether to the adhesive mount, and the other end to the rear cover shaft.
3. Assemble the base, pre-tightening handle and adhesive mount according to the direction
illustrated in the picture. First press the base into the adhesive mount, and then rotate and
tighten the pre-tightening handle.
4. Tack the double-sided adhesive at the bottom of the adhesive mount to the object to be
used.
Double-sided adhesive is disposable. It can be purchased separately and replaced if
needed.
Pre-tightening Handle
Tether
Adhesive Mount
Double-sided adhesive