Scanner User's Guide

A-61560 June 2006 81
Blank image detection — select the image size (KB), below which an
image is determined to be blank. Images with sizes less than the
number you select will not be created. If you use this option, you must
specify a blank image size for each image type (Binary, Gray and
Color) you want to delete. If you do not make an entry in these fields,
all images are kept.
Multi-feed Detection options
Length Detection  this option can be enabled or disabled. The
default is disabled. If enabled, select the maximum length of the
document that can be scanned without a multi-feed being detected.
Length detection is used when scanning same-sized documents to
check for overlap. For example, if you are scanning 8.5 x 11-inch (A4)
documents in portrait mode, enter a value of 11.25 inches (28.57 cm) in
the Maximum Length field. The maximum value is 13.99 inches (35.56
cm).
• Auto Set: automatically sets the maximum length value to .50-inch
(1.27 cm) greater than the length of the currently selected page size.
Ultrasonic Detection — check this option to set multi-feed detection.
Sensitivity — controls how aggressively the scanner will work to
determine if more than one document is fed into the transport. Multi-
feeds are triggered by detecting air gaps between documents. This
allows multi-feed detection to be used with job sets containing
documents with mixed thicknesses. You may set the Multi-Feed
Detection to High, Medium or Low sensitivity.
• Low: the least aggressive setting and is less likely to detect labels,
poor quality, thick or wrinkled documents as multi-fed documents.
• Medium: use Medium sensitivity if your application has varying
document thickness or labels attached to the document. Depending
on the label material, most documents with labels should not be
detected as a multi-fed document.
• High: the most aggressive setting. This is a good setting to use if all
documents are similar in thickness to 20-lb. Bond paper.
Action — select an option of how you want to the scanner to perform if
it detects a multi-fed document.
• Beep and continue: if selected, the scanner will beep, display and
log the condition but continue to operate.
• End of Job: if selected, the scanner log the condition and stop the
feeder and transport (the scanner will be disabled).
Alarm - select this option if you want the scanner to make a sound
when a multi-feed is detected. You can click the Speaker icon to
display the Open dialog box. From the Open dialog box, select the
desired .wav file and click OK.
Calibrate — the Kodak i1200/i1300 Scanners automatically calibrate.
This option is available if a Kodak representative directs you to calibrate
the scanner using this option.