Scanner User's Guide
Table Of Contents
- 1 Introduction
- 2 Getting Started
- What’s in the box
- System requirements
- Installing the scanner
- Installing the Kodak Driver Software
- Connecting the power cord to the scanner
- Connecting the USB cable
- Attaching the output tray
- Turning on the scanner and finalizing Kodak Driver Software installation
- Installing application software
- Scanner components
- Locking the scanner
- 3 Using the Scanner
- Turning the scanner on and off
- Scanner positions
- Tilting the scanner body
- Adjusting the output tray
- Adjusting the input tray
- Adjusting the side guides
- Start and stop scanning
- Document preparation
- Verifying your scanner installation
- Viewing test images
- Understanding your scanning environment
- Smart touch functionality
- Scanning your documents
- 4 Image Processing
- Overview
- Starting the Scan Validation Tool
- Scan Validation Tool dialog box
- Using the TWAIN datasource
- The main Kodak Scanner window
- The Image Settingswindow
- Preview window
- Toolbar icons
- General tab
- Size tab
- Adjustments tab: black and white
- Adjustments tab: color or grayscale
- Enhancements tab
- Advanced options
- Content Settings tab
- Setting up automatic color detection - Example 1
- Setting up multiple images for each side of a document (dual stream) - Example 2
- Using different settings for each side of a document - Example 3
- Images for each side of a document (dual stream) - Example 4
- The Device Settings window
- The Diagnostics window
- Using the ISIS Driver
- 5 Maintenance
- Cleaning the scanner
- Opening the scanner cover
- Cleaning the rollers and transport
- Cleaning or replacing the separation module
- Replacing the separation module tires
- Cleaning or replacing the feed module
- Replacing the tires on the feed module
- Vacuuming the scanner
- Cleaning the imaging area
- Supplies and consumables
- Accessories
- 6 Troubleshooting
- Appendix A Specifications
- Appendix B Feature Map
- Appendix C Warranty - US and Canada only
A-61560 June 2006 25
The main Kodak Scanner window will be displayed.
NOTE: When you access the main Kodak Scanner window, refer to
Chapter 4, Image Processing for more information on how to get
started using the TWAIN datasource or ISIS driver.
4. Select Defaults. A confirmation message, Reset all values to
factory defaults will be displayed.
5. Click OK. This resets the software to the factory-installed default
settings. The factory default settings are set to capture color
images.
6. Place some test documents into the input tray of the scanner.
7. Click the Start button on the Scan Validation Tool dialog box. The
documents will be scanned and displayed in the Scan Validation
Tool window. Be sure that one of the window display icons is
selected, otherwise the scanned image will not be visible.
NOTE: If the scanner is in lamp saver mode, a message will be
displayed that the lamps need sufficient time to warm up.
After the images have been displayed, your scanner installation
verification is completed.
8. Click the Close box to exit the Scan Validation Tool.
Window
display icons