Scanner User's Guide
Table Of Contents
- 1 Introduction
- 2 Getting Started
- What’s in the box
- System requirements
- Installing the scanner
- Installing the Kodak Driver Software
- Connecting the power cord to the scanner
- Connecting the USB cable
- Attaching the output tray
- Turning on the scanner and finalizing Kodak Driver Software installation
- Installing application software
- Scanner components
- Locking the scanner
- 3 Using the Scanner
- Turning the scanner on and off
- Scanner positions
- Tilting the scanner body
- Adjusting the output tray
- Adjusting the input tray
- Adjusting the side guides
- Start and stop scanning
- Document preparation
- Verifying your scanner installation
- Viewing test images
- Understanding your scanning environment
- Smart touch functionality
- Scanning your documents
- 4 Image Processing
- Overview
- Starting the Scan Validation Tool
- Scan Validation Tool dialog box
- Using the TWAIN datasource
- The main Kodak Scanner window
- The Image Settingswindow
- Preview window
- Toolbar icons
- General tab
- Size tab
- Adjustments tab: black and white
- Adjustments tab: color or grayscale
- Enhancements tab
- Advanced options
- Content Settings tab
- Setting up automatic color detection - Example 1
- Setting up multiple images for each side of a document (dual stream) - Example 2
- Using different settings for each side of a document - Example 3
- Images for each side of a document (dual stream) - Example 4
- The Device Settings window
- The Diagnostics window
- Using the ISIS Driver
- 5 Maintenance
- Cleaning the scanner
- Opening the scanner cover
- Cleaning the rollers and transport
- Cleaning or replacing the separation module
- Replacing the separation module tires
- Cleaning or replacing the feed module
- Replacing the tires on the feed module
- Vacuuming the scanner
- Cleaning the imaging area
- Supplies and consumables
- Accessories
- 6 Troubleshooting
- Appendix A Specifications
- Appendix B Feature Map
- Appendix C Warranty - US and Canada only
98 A-61560 June 2006
3. Replace each tire by sliding the tire off the core.
4. Install each new tire by gently pulling it over the core.
IMPORTANT:Do not overstretch the tire; it may tear.
5. Replace the core assembly in the feed module. You may need to
slide the shaft so the core fits properly within the feed module
housing.
6. Repeat the replacement procedure outlined above for the other core
assembly.
7. Reinstall the feed module.
8. Reinstall the feed module cover by aligning the tabs in the slots and
pushing the feed module cover down until it snaps into place.
Core assembly
Slide shaft