Operation Manual

1-10

Setting Up the Printer

12. Insert each cassette until it clicks into place.

13. Rotate the thermal head release lever on the left side (labeled

L1) and/or the right side (labeled R1) up to the locked position.

14. Close the front door.

Making a Test Print

Make a test print to check that the printer is installed and set up

correctly.

1. On the operator panel, press

Menu twice until Te s t P r i n t

Mode appears.

2. Press

Enter to start printing the test print.

3 . To e x i t Te s t P r i n t M o d e , p r e s s

Rewind/Unload until

8x10 YMC-YMC or 8x12 YMC-YMC appears.

For more information on using the operator panel in Setup mode,

see “Printer Settings” on page 2-3.

Enter

Rewind/Unload

Advance/Load