User manual

Focus the Camera- Rotate the Lens Mount -
Selector Ring combination until the figure repre-
senting the camera-to - subject distance in feet
(between 5 and 25 ) is opposite the focus index.
Be careful not to depress the selector ring lock while
focusing.
NOTE : The focusing scale controls lens openings for fla sh
in the 5 to 25-foot distance range , only . Distance limits at
which scale can be set are determined by the guide number.
Aim the Camera-Look through the viewfinder
and compose the picture within the luminous view-
frame of the viewfinder. The flash symbol should
appear in the base of the view-trame-if not,
check the setting of the selector ring.
NOTE : Disregard the possible appearance of the low light
signal with nash pictures.
Release the Shutler-Hold the camera steady and
press the shutter release down with a slow, sQueez -
ing action to take the picture. If film has not been
advanced, or if film leader has not been wound
off fully, you cannot press the shutter release.
Advance the Film-Swing out the rapid wind
lever one full stroke, or several short ones, until
it locks; then let the lever return to its original
position. After the 20th or 36th exposure and before
opening the camera, the film must be rewound into
the magazine. See Unloading, page 8.