Datasheet

KODAK PROFESSIONAL T-MAX Films • F-4016 5
Adjustments for Long and Short Exposures
At the exposure times in the table below, compensate for
the reciprocity characteristics of these films by increasing
the exposure as shown.
Filter Corrections
The filter corrections for T-MAX 100 and T-MAX 400
Films are the same.
Increase exposure by the filter factor or the number of
stops indicated when you use filters. For greatest exposure
accuracy with a through-the-lens meter, take the meter
reading without the filter over the lens, and then increase
your exposure as shown in the table.
Note: Filter factors for other Kodak black-and-white films
are different.
T-MAX 100 Film
If Indicated
Exposure Time Is
(Seconds)
Use This
Lens-Aperture
Adjustment
OR
This Adjusted
Exposure Time
(Seconds)
1/10,000 +1/3 stop
Change
Aperture
1/1,000 None None
1/100 None None
1/10 None None
1+1/3 stop
Change
Aperture
10 +1/2 stop 15
100 +1 stop 200
T-MAX 400 Film
If Indicated
Exposure Time Is
(Seconds)
Use This
Lens-Aperture
Adjustment
OR
This Adjusted
Exposure Time
(Seconds)
1/10,000 None None
1/1,000 None None
1/100 None None
1/10 None None
1+1/3 stop
Change
Aperture
10 +1/2 stop 15
100 +1 1/2 stops 300
KODAK WRATTEN Gelatin
Filter
Daylight Tungsten
Increase Lens
Aperture By
(f-stops)
OR
Increase Exposure
By (Filter Factor)
Increase Lens
Aperture By
(f-stops)
OR
Increase Exposure
By (Filter Factor)
No. 8 (yellow) 2/3 1.5 1/3 1.2
No. 11 (yellowish green) 1 2/3 3 1 2/3 3
No 12 (deep yellow) 1 2 1/3 1.2
No. 15 (deep yellow) 1 2 2/3 1.5
No. 25 (red) 3 8 2 4
No. 47 (blue) 3 8 4 2/3 25
No. 58 (green) 2 2/3 6 2 2/3 6
Polarizing Filter 1 2/3 2.5 1 1/3 2.5