manual

7
Duct Cover Installation
6. Use 6” round steel pipe for 30” and 36” models or
8” round steel pipe for 42” model (follow building
codes in your area) to connect the exhaust on the
hood to the ductwork above. Use duct tape to
make all joints secure and air tight. Refer to
Figure 5.
7. Use four 4mm x 8mm screws (included) to attach
duct cover to hood. Refer to Figure 6.
Install Accessories
8. Attach oil tunnel. Refer to Figure 7.
9. Refer to Figure 23.  Slide the baffle filter into
the hood.  Push the baffle filter upward. 
Slide forward.  Pull downward.  Fit into
place.
10. Repeat until all baffle filters and spacers are
resting against oil tunnel. Refer to page 8.
Final Assembly
11. Turn power ON in control panel. Check all lights
and fan operation.
12. Make sure to leave this manual for the
homeowner.
Figure 7
Figure 8