Manual

7
Wiring to Power Supply
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT POWER
FROM BEING SWITCHED ON ACCIDENTALLY.
12. Route house wiring into the ceiling as close to the
installation location as possible. Allow additional
length of wiring to drop down from the ceiling to the
electric box.
13. Connect the electrical wires according to color
(green to green, white to white, and black to black)
and cap with wire connectors. Green wire must be
grounded to reduce risk of electric shock.
Ductwork Installation
14. Use 6” round aluminum or steel pipe (not provided)
to connect the plastic
15. Place the two sections of the inner duct cover on the
telescopic stack and clip together. Secure it to the
top of the telescopic stack with two 4mm x 8mm
screws and conical screw washers (provided).
16. Place the two sections of the outer duct cover on the
telescopic stack and clip together. Slide it downward
so that it sits properly on the hood.
Final Assembly
17. Install the Baffle Filters.
18. Turn power ON in control panel. Check all lights and
fan operation.
19. Make sure to leave this manual for the homeowner.
Duct Cover Installation