- KOBE INSTALLATION INSTRUCTIONS AND OPERATION MANUAL Range Hood CH0030SQB, CH0036SQB, CH0042SQB, CH0048SQB

MAINTENANCE

For the optimal level of operation, clean the range hood surface and baffles regularly.

To Clean Hood Surface

CAUTION: NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHS.

*** Regular care will help preserve its fine appearance.

1. Use only mild soap or detergent solutions. Dry surfaces using soft cloth.

2. If hood looks splotchy (stainless steel hood), use an orange base cleaner to clean the

surface of the hood. Avoid cleaner to get on the control switches. Only spread a light

coating over the surface of the hood and leave on for a few minutes (do not leave on too

long or this may cause damage to hood finish). Use soft towel to wipe off the cleaning

solution, gently rubs any stubborn spots. Use a slightly damp towel to get rid of any cleaning

solution. Use dry soft towel to dry the hood.

3. To bring the glow back into a stainless steel finish, use a stainless steel cleaner.

4. DO NOT allow deposits to remain for long periods of time.

5. DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the

surface causing rust.

6. DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in

contact with stainless steel for extended periods. Many of these compounds contain

chemicals, which may be harmful. Rinse with water after exposure and wipe dry with a

clean cloth.

To Clean Baffle Filters

CAUTION: DRAIN BAFFLE FILTERS BEFORE OIL WILL OVERFLOW.

1. Remove the baffle filters by sliding forward and pull downward.

2. Wash with warm soapy water. Dry completely before returning into place.

(Note: Baffle Filters are top rack dishwasher safe.)

CAUTION: HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL.

   

1. Make sure all controls are off, and range hood is unplugged.

2. Place the flat-headed screwdriver into the groove of the halogen light glass covering and the

housing.

3. Pop out the halogen light glass covering.

4. Gently pull out the defective light bulb and discard. Light bulbs should be 12V 20W

maximum.

5. Using a cloth, hold the new light bulb and push securely into light socket.

6. Return halogen light glass cover to the housing.

7. Turn range hood ON to test for operation.