Installation Guide

3
ASSEMBLY
10-16 X 1 Phillips screw (4)
1/4-20 Hex Nut (16)
14-10 X 3/4 Phillips screw (4)
HARDWARE INCLUDED
Release
Some instructions may not apply to
your specific unit.
SIDE HANDLE ATTACHMENT:
NOTE: Holes in the cabinet are tapped
requiring no nuts for installation.
C Side handle should be mounted on
the same side of the cabinet as the
swivel casters.
C Attach the side handle using (4) 14-
10 x 3/4 phillips screws.
C Wrench tighten the screws.
PLASTIC TOP INSTALLATION:
Note: Use adequate personnel for
this operation.
NOTE: The top is shipped snapped
onto your unit. It is recommended that
you bolt the top down.
• Remove the top two drawers to gain
access to the holes pre-drilled in the
metal top.
• Place the cart on its top. Use
packaging material to protect the
paint finish.
• Attach top using (4) #10-16X1
screws.
CASTER INSTALLATION:
Note: Use adequate personnel for
this operation.
C Note: Mount both swivel casters on
the same side of the unit as the
handle.
C Attach casters using four 1/4-20 hex
nuts on each caster.
C Wrench tighten all fasteners.
C Return the unit to its upright position.
• Reinstall drawers.
REMOVING AND INSTALLING
DRAWERS:
• Empty the drawer.
• Fully extend the drawer.
4
Lever Style - Lift or
lower (depending on the
slide) the release lever
on both sides, (this
allows the slides to ride
over the stops.) Pull out
to remove.
MAINTENANCE
Tab Style - Depress the
release tabs on both
sides, (this allows the
slides to ride over the
stops.) Pull out to
remove.
To reinstall, carefully
align the slides and push
the drawer into the unit
until the drawer stops.
Spring
retainer
REMOVING AND INSTALLING
SLIDES:
NOTE: To remove the slide from the
unit, first remove the drawer (Follow the
procedure above.)
NOTE: After removing the drawers
check to see if your unit has rivets
located on the front and back of the
slide. (To drill out the rivets, use a
5/32" drill bit. The rivets do not need
to be replaced.)
• Lift and hold the spring retainer, and
push the slide upward. The slide may
now be removed.
• To reinstall the slide, place the slide
in the appropriate position in the unit
and pull toward the front of the unit
until the spring retainer snaps into
position and secures the slide.
• For smooth operation, make sure the
drawers are matched with their
original slides.
C For casters, use high quality bearing
grease, (yearly).
C Lubricate the slides, (twice yearly).
C Lubricate lock with graphite, (yearly).
C Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and
water.
C Auto wax will preserve the storage
unit’s luster finish. Apply the wax as
to a car. The wax will also help
protect the unit against scratches.
C Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable cleaning
fluid.