Use and Care Guide

9
REPAIR INSTRUCTION
Remove air pressure from air hose / gun.
CAUTION:
Take care not to damage the seals on the gun body when removing the
air distribution ring.
1. Remove the nozzle set:
a. Remove air cap w/ring by turning counter clockwise (See Figure 1).
Counter clockwise
Counter clockwise
b. Unscrew the fluid adjustment knob by turning counter clockwise (See Figure 2).
c. Pull out needle spring and paint needle (See Figure 3).
d. Remove paint nozzle using wrench provided (See Figure 4).
4
2. Pull out the air distribution ring using needle-nose pliers
and remove dirt (See Figure 5).
3.The clean air distribution ring must be inserted in a way that the plastic pin marked
with an arrow (1) fits smoothly into the hole marked (2) (See Figure 6). Firmly push
in the air distribution ring in place (See Figure 7). Insert the paint nozzle and tighten
11 2 3
(not included)
slightly. Make sure the air distribution ring fits securely against the gun body.
5
NOTE: Make sure that dirt has not settled in the sealing surfaces and no scratches
prevent optimum sealing performance. Use care and caution not to damage the air
distribution ring. Reconnect air hose with spray gun set to desired PSI.