Use and Care Guide

Air Valve Spring

Pattern Control

Knob

Fluid

Control

Knob

Fluid Needle

Spring

Change of Feed Method

This latex spray gun is capable of pressure or

siphon feed. The feed method can be easily

changed by fully turning the side knob. You should

be sure to choose the proper feed method first.

(See Figure 1)

SPRAY GUN SET-UP

P: Pressure feed

S: Siphon feed

Non-Bleeder to Bleeder Conversion

(See Figure 2)

1. Remove spray gun from air supply.

2. Remove fluid control knob and the fluid needle

spring.

3. After removing air valve spring store it in a safe

place so it can be attached when necessary to

convert back to a non-bleeder spray type.

4. Insert fluid needle spring and replace fluid

control knob.

Before beginning assembly of product, make sure all parts are present. Compare

parts with package contents list. If any part is missing or damaged,do not attempt to

assemble the product. Contact customer service for replacement parts.

Estimated Assembly Time : 5 - 1 0 minutes

Tools Required for Assembly (not included): Adjustable wrench

PREPARATION