Use and Care Guide

Paint too fine

Correct

Paint too coarse

Pattern Consistency (Atomization)

6-9 in.

Thin coat Heavy coat Thin coat

4. With

OPERATING INSTRUCTIONS

5. Keep the gun at the right angle as shown while

spraying. (See Figure 5)

NOTE The fluid control knob (G) can be adjusted

either clockwise or counterclockwise to finely

consistency. Before spraying on

workpiece, practice a few minutes on a cardboard

target to ensure that the pattern size and

consistency are set correctly.

NOTE Always keep the gun in motion while

spraying. Stopping gun movement in mid-stroke

will cause a build-up of paint and will result in runs.

Do not fan the gun from side to side while painting.

This will cause a build-up of paint in the center of

stroke and an insufficient coating at each end.

(See Figure 6)

the spray gun 6 in. to 9 in. away from

workpiece, spray a short burst while turning the

fluid knob counterclockwise. Observe the spray

pattern on the workpiece and adjust the fluid

control knob (G) until desired pattern/atomization

is obtained. If the spray is too fine (caused by too

much air), reduce the air pressure or open the

fluid control knob (G) to spray more paint. If the

spray is too coarse (or is spitting blobs), reduce

the amount of paint with the fluid control knob

(G) or thin the pain more (See Figure 4).

adjust the pattern

the