Use and Care Guide

ASSEMBLY INSTRUCTIONS
10
2
3
1
1. Remove the air inlet protective cap from the
air inlet (J) (See Figure 1).
3. Mount a male plug (not included) by hand into
the air inlet (J) (See Figure 2).
4. Place 2 - 3 drops of air tool oil (not included)
into the male plug before each use
(See Figure 3).
NOTE
NOTE
J
J
Use threaded sealant tape (not included)
on the threading of the male plug. Once sealant
tape is properly in place, tighten male plug turning
clockwise with a wrench (not included) for air tight
connection. DO NOT OVERTIGHTEN.
This machine's gears should be lubricated
every working day of use. This tool has a
flush-type grease fitting (G) (See Figure 3).
Please consult your local retailer for assistance on
which type of grease gun to use with this type of
fitting.
1
2
3
1
2
3
1
2
3
2.