Use and Care Guide

ASSEMBLY INSTRUCTIONS
7
7. Connect air supply hose to the male plug. Set
the working pressure at 90 PSI for best tool
performance (See Figure 7).
OPERATING INSTRUCTIONS
1
2
1. Push the forward/reverse lever to the "F"
position. Press the trigger (E) and the tool
chuck runs clockwise for drilling on workpiece
(See Figure 1).
2. Push the forward/reverse lever to the "R"
position. Press the trigger (E), and the tool
chuck runs counterclockwise for releasing the
drill bit out of the workpiece (See Figure 2).
12
NOTE Working pressure refers to the air line
pressure set to the tool when the tool is under
working conditions.